Discussion Locked

Switches, hubs, and things.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I heard it is better for a buisiness network environment to have everything on switches rather than hubs. MY network is running at 10 MBps I would like to get it running at 100 MBps or close to it.

Thank youse,
Doug Carter

5 replies

by barry hensley

Switches are much more effecient at controlling LAN traffic because they pass traffic ONLY to the switch port belonging to the destination host rather than broadcasting every packet to every port like a hub. When one host on your network is communicating with another host on the same network, a switch will isolate that traffic so that other hosts do not see it at all.

With the cost of switching coming down so rapidly, I would highly recommend retrofitting your network with 10/100 switches. These devices will autodetect the speed of the NIC in each host and adjust accordingly. You can support BOTH 10Mbps and 100Mbps devices on the same switch at the same time.

I recommend purchasing manageable, stackable switches, all from the same manufacturer. Install the manufacturer's management software and you will be able to control and monitor traffic at each port on every switch.

by lomex

- Hubs share a single internal repeater and ports are half duplex (meaning alternating tx and rx)
- Switch have dedicated internal repeaters for each port and transmit signal in full duplex (simultaneous tx and rx)
- Manageable switches can control incoming and outgoing packets at a given port based on the defined MAC addresses of packet
- Router switches can control incoming and outgoing packets at a given port based on the MAC addresses, protocol,IP/IPX/appletalk/ etc.. address of a packet

Elmo Bringas

This discussion is closed to new replies.