Question Locked

Synaptics Touchpad problem with Acer Notebook

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an Acer Aspire 5100 for 1 and half year now.

I was forced to change my DC adaptor when Acer's collapsed lol so I went and bought one from the local store doing the same ol' job, but not being Acer's. Acer was out of stock back that time.

Anyway, when I first plugged it, my Touchpad (Synaptics brand) started to act weird.

It was freezing, and while the heat inside the laptop was rising, touchpad was not functioning at all, by remaining still frozen.

Could it be a coinsidence? Or the adaptor makes up the whole problem?

3 replies

by older mycroft

[i]"..while the heat inside the laptop was rising.."[i]

Are you seriously saying you could feel the heat rising inside the laptop?

What is the rating of each adaptor, Acer's and the replacement?

by oh smeg

What is the Direct Current Voltage Rating of the new adapter compared to the old one. If it is different by more than .5 of a Volt you shouldn't be using it as it will cause damage.

Also check to see if there is something blocking the Air Intake for Cooling on the bottom of the NB and if there is clear it as the NB shouldn't be getting hot.

You may need to clean out the NB Air Chanel's to allow proper cooling again and ideally if it is continuing to heat up use a Cool Pad like this one.

http://tinyurl.com/ny8zn

There are quite a few brands of these available so have a look around for one that suits you.

Col

This discussion is closed to new replies.