Discussion Locked

System Alarm

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just installed a new HD (13.6GB) and now the system "beep" alarm goes off rabdomly for a consistant 1 1/2 mins. Everything runs fine while beep is in process, but slightly slower. I've tried everything and am stumped. Any useful tips would be appreciated.

7 replies

by jahaja

Have you switched the disks right, master and slave? I suspect one of your disks is switched to “Cable select”. Also check the BIOS setup for disks, should be set to “Auto” on all parameters.

PS! Make sure you “ground” your self before touching any parts inside your computer. Do NOT touch any integrated circuits (only touch edges).

Jan

by bdgray

I believe it is one of two things. First, the addition of this new drive could be generating enough additional heat to set off your mainboards temperature alarm. The slowdaown in conjunction with the beep is a good indication of this. Add an addition exhaust fan to your computer or get a better CPU fan with a cfpm rating of at least 20.

Second, you may have a cheap power supply that can't handle the current your system is now pulling. I would no get anything less than a 300W power supply. Especially if you still plan on adding new HW to your system. Intermittent hard to replicate problems are often caused by power supplies.

This discussion is closed to new replies.