Discussion Locked

System freezes during win95 setup

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My system keeps freezing and giving me errors when i do an install... what is happening here?

15 replies

by dmiles

Not knowing the error being given,I would suggest doin a clean install by Fdisk,and reformatting the hard drive,using boot disk and cd-rom,at the command prompt type FDISK,and follow the onscreen instructions.

by vijaychandran

It means any one of your hardware - most probably the display card is creating the problem. Sort out and change the problematic hardware and try installation. Good luck !

by chris_surgenor

This could be any number of things depending on the errors you are getting. It is however most likely to be a hardware problem. My gut reaction is the graphics card. You don't say if this is a fresh install but I would be inclined to format the harddisk and make sure that any anti virus software in the BIOS has been set to off. IO sys errors usually point towards motherboard or CPU faults.

by eperez

Here are several checks you can perform:
1-If your machine freezes before the first reboot I suggest going into the BIOS and if possible change "Video bios cacheable" and "system cacheable" parameters to OFF. Later, when you're over, try changing them back to ON.
2-Disable any on board antivirus.
3-Make sure that if your motherboard lets you modify a parameter that reads "Init display first" the setting must point to the appropiate setting: AGP for AGP graphic cards (in slot or mobo based) or PCI for in slot cards.
4-Make sure you are not overclocking. My personal experience is that Win95 a/b does not like overclocking. Go figure. Check CPU definitions and RAM speed. If you're trying to set-up Win95 then it sounds like it is an old computer so your RAM must be like 66mhz.
5-if nothing else works, go to setup and try resseting ALL parameters to BIOS DEFAULT do not reset them to SETUP DEFAULT.
6-Last, try to post your machine data. We are playing blind here...
Hope it works,

by jyimcse

Are you installing on a system that had Windows 95 before? Does the system meet Hardware requirements? Are you using LBA mode for your hard drive?

by emmac

the last time I saw this proble,m it was caused by saying yes to create a boot disk when prompted. after you click yes the system freezes.

by ddansereau

I had a long and I guess good learning experiance with a similar freezing problem.
I hope my solution may also help you.
As you have found out, the computer has no way of telling you during an install exactly what's not working or set up properly in your computer. So you really need to eliminate as many variables as possible. What I did was to disconnect all divices and have just the master hard drive, floppy drive, Cd rom drive, and video card connected.(of course keyboard, mouse, and monitor connected)I'm assuming your installing Windows on a freshly formatted and partitioned hard drive. I used this proceedure and have found that if the jumper pins on the motherboard are set correctly, Windows will install without a problem. If it still locks up(blue screen, registry errors,etc.) Check the settings (jumper pins)for the memory chips, and also make sure they're (memory) installed correctly. If all seems OK and you're still getting errors,(locks up at the last part of the windows install) It very well ma

This discussion is closed to new replies.