Discussion Locked

T-1 and TCP/IP Network Interface

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm having GREAT difficulty with stability of our local network (12 users) and keeping our Cable ISP link up through our Linksys Cable Router. I feel most of the problem is on the Cable provider side, but they are reluctant to admit it. I have 256K bandwidth available with our phone service and am tempted to switch our Internet access from cable to the T-1 line and add a couple more channels for increased bandwidth. There's already a data port (RJ45) on our telephone gear switchbox that I can access by one PC. What equipment do I need to interface this T-1 data port with my existing network? Is this something best left to the pros or is it no more involved than hooking up the cable modem access?

5 replies

by timwalsh

It's impossible to give you an answer with out knowing the capabilities and specifications of your phone system. I would be willing to bet that the data port is merely a means for a technician to connect a laptop to the phone system for programmingor troubleshooting purposes. You need to look through the documentation for your phone system or talk with the system vendor to determine what the purpose of the data port is.

by road-dog

BEFORE GETTING ALL FIRED UP ON THE T-1...

look more closely at the existing situation. You might want to consider running an extended PING to your router local interface and to your DNS or default gateway within the cable provider and isolate theproblem to the cable provider.

A properly equipped Consultant should be able to isolate this for you. He will need to perform a packet capture on the LAN to see if there is anything of note there.

This RJ-45 port is almost undoubtedly a serial management port, not an available Ethernet or T-1 port.

If you are serious about splitting the T-1 between voice and data, check pricing with Ma Bell and see what the additional cost is. If it looks like a good choice, then drop a split mux in the middle. Port the voice DS0s to the Key system or PBX and the data DS0s to a serial interface on a low end router.

The phone company might give you a price on the hardware / install. If not, hire a local networking company to do the job.

This discussion is closed to new replies.