Discussion Locked

T1 Line Speed: 1.544Mbps each way?

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The rated speed of a T1 line purchased from the phone company is 1.544 Mbps. Is that the speed in each direction -- i.e., theoretically 1.544 Tx max. and 1.544 Rx max.? Or is it 1.544 Mbps total -- that is to say, Tx speed + Rx speed = 1.544 max. ?

14 replies

by wlbowers

If it is a full T1 that will be the speed both ways. Another thing to check is if that is the full time speed rate. Some times a T1 will be sold with a full speed rating but comes with a commited information rate. This means that you have a T1 but they only guarantee x-amount of speed all of the time. In other words if they need the bandwith on their slick that you are riding on they will cut you back to the "cir".

More to consider. ADSL is considered to be T1 speed but is limited on the upload side usually to about 300K.

The best thing to do is get with the tech support of your vendor. They can answer all of your questions.

Good Luck Lee

by emorse

It is a synchronous connection. Therefore, this is the speed you get in each direction.
- Eli

by mike mullins

1. Line speed is 1.544 Mbps in both directions.

More importantly throughput is
1,544,000 bits - 8000 bits overhead = 1,536,000 bits/second, which yeilds
1,536,000 / 8 (bits/byte) = 192,000 bytes/second.

Good Luck

by otl

Answer 5 came the closest - Depends on line coding and framing of the DS1.

D4 - AMI available bandwidth is 1.344 M

B8ZS - ESF available bandwidth is 1.544 M

Overhead is dependant on how many layers of encapsulation are added to get the datato the correct termination point.

You did not mention if this is Point-To-Point, Frame Relay, or a direct internet connection.

Point-To-Point - Full bandwidth available minus your overhead

Frame Relay - This is your access circuit not the CIR (Committed Information Rate), BR (Burst), or BE (Burst Excess)

direct internet connection - This only gets you to your ISP's Gate and depending on their access circuit divided by the bandwidth they committed to/sold your CIR to the internet could be choked at the ISP.

by sharkini brother #2

My thanks all 6 of you for your responses! This T1 speed issue came up recently at a meeting and suddenly what seemed logical (i.e., a generic T1 is 1.544 each way) came into question. (It reminded me of relay control logic in the early 80's where "normally open" contacts sometimes was defined as "normally open in the relay's usual operating state". The point being that "usual operating state" could be when the relay coil is energized, and not its off-the-shelf state. Anyway, thanks again.--- S

This discussion is closed to new replies.