Discussion Locked

Tape Hardware Problem

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Have been running this tape backup for a few years, consistantly backs up on a nightly basis. this morning seagate reports error running job. I notice the tape device is not registered in the seagate. I go to NT backup and it reports a tape device is detected but is not responding....
i then go to control panel tape devices and rescan, still there. then i go to devices and try to stop the 4millim device, states unable to stop, and the function to stop it is no grayed out. I have three other tape drive identical to this one in other servers.
what if any is the solution without rebooting my server?

thanks

3 replies

by xiopus

I believe your problem is trying to use the 4mm NT furnished driver with the Seagate software, it seems if I remember correctly that the seagate software has it's own driver for the tape unit and you must first remove the 4mm tape driver from the system, once this is removed you may add the device under the seagate backup software (I don't remember where exactly). Check you documentation for specifics.

This discussion is closed to new replies.