Discussion Locked

taskman summary not = detail breakdown

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm trying to track down a memory leak the non-paged memory pool/threads/handles in NT Small Business Server 4.5 (NT 4.0 Sp 6a) and I used taskman to give me a snapshot of the non-paged memory usage. I hit the "pause" to freeze the detailed data oneach process. After totalling the numbers reported on the detailed data, I compared it to the summary data. The detailed data and the summary data don't match for the nonpaged memory. The detail and the summary match for the handles and the thread counts, so I'm confused. Am I missing something?

I was using perfmon and had the same problem. I switched to taskman thinking I did something stupid like not converting bits to bytes or something like that but I've got the same problem again.Anyway, the damn server crashes when I run out of nonpaged memory about every week. I've already setup a weekly reboot using the AT command, but that just is not a good fix in my mind.

2 replies

by timmm_30

I am not sure but you did not mention your RAM setup. Do you have combined RAM and disabled ECC in the BIOS? if so try matched RAM. I had the exact same problem and installed matched RAM. This stopped the automatic reboot when the server started to page to the disk.
Tim

by ironchef

matched RAM.... I've got 128 MB ECC RAM and will soon be adding another 256 MB ECC. I don't think the ECC has been disabled in the BIOS, but I don't think so as this server (Proliant 1600) was set up by a Compaq service provider.

as for the rest of the server specs: P II 350, 9 GB hard drive (mirrored), running NT SBS 4.5 sp 6a and Exchange 5.5 SP 4. Using ArcServe for backups and InoculateIT for AV software.

This discussion is closed to new replies.