Discussion Locked

TCP/UDP broadcast forwarding

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello!
Is there a way to forward TCP and UDP broadcasts over subnets with the help of software/WinNT server?
What I want to do is the following: I want to forward the broadcasts DirectPlay is doing on port 47624 when it is searching for game sessions (please correct me if this is wrong). The problem is that many newer games don't allow the user to specify the IP of a game server but instead rely on the auto-search of DP which makes them unplayable if the game host is located in another subnet.

I would appreciate any hint you can give.
Many thanks in advance.
Regards. M.F.

7 replies

by pete.zerger

On the server in the Network Properties icon, select TCP/IP, hit properties, and then on the Routing tab check the box next to 'enable IP forwarding'. Then the server acts as a router that will forward all IP traffic.

Make sure there aren't any dedicated routers between you (like Cisco routers, etc) as normal routers drop broadcasts by default.

by infosec-poc

I do not believe that turning on IP FORWARDING will do what you want. That function is for routing packets, not forwarding broadcasts.

If you have a cisco router routing between subnets, try the following:

#1 go into enable mode on the router and then go to each interface that you want to forward broadcasts and type in the command "ip directed-broadcast"

#2 if you know where the broadcasts should be sent "ip helper-address x.x.x.x" with the sister statement "ip forward-protocol udp 47624". These commands have to be placed on the interface that will 'hear' the broadcast.

by clpadmin

Hum, this is a longshot but..

you can try and modify the route table,
i.e. route -p add 192.168.1.255 mask 255.255.255.255 192.168.2.1

and

route -p add 192.168.2.255 mask 255.255.255.255 192.168.1.1

where 192.168.1.1 and 192.168.2.1 arethe addresses for each network card on the Windows NT that does the routing.

This discussion is closed to new replies.