Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Setting up additional NT 4.0 Servers running TCPIP connected through cabletron routers. I'm using Class A IP scheme. I'm able to ping both ethernet interfaces on the routers, but nothing behind the routers such as servers, workstations. Any input isgreatly appreciated
7 replies
by dmiles
Go back over the TCP/IP settings to make sure that you have IP addresses to computers are set properly,make sure you have the subnet mask configured properly for router to work properly.
by rminter
Poster rated this answer
by rogueldr
Make sure the cabletron channels are set for data and not voice.
by rminter
Poster rated this answer
by mckaytech
It sounds like you haven't defined any routes within the routers. I'm not familiar with Cabletron syntax, but you need to tell the router that packets destined for Subnet A need to go out InterfaceA and so on.
Probably the place to start is to telnet into the router and print the routing table.
You should see a line for each interface (at the very least).
Hope that helps you get started.
paul
by rminter
Poster rated this answer
by rminter
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
2 helpful
26 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
16 replies
0 helpful
3 replies
0 helpful
6 replies
0 helpful
12 replies