Discussion Locked

Testing cat 5

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm connecting a peer-to-peer networking running about 50ft of cat5 cable. Once I crimp the RJ-45 clip how can I test the cable to see if I have a good connection? Is there a tester I can buy, and if there is where can I purchase one. Or can I make a tester.

5 replies

by thechas

Many places that sell CAT5 and other data cables have testers available. As to whether or not you can justify the cost is a question.

To test the cables your self, make a box with 2 Cat5 jacks wired to a barrier strip.
Plug in the cable, and check for both continuity, and shorts with an ohm-meter.

by jereg

You need an ethernet cable tester. You can get them just about anywhere, but be careful. CompUSA will sell you a cable tester for about $100. It can be purchased anywhere else for half that. I like to use Computer Discount Warehouse: www.cdw.com
You can get a low end cable tester for $50 (#125645). It will check for opens and shorts in the cable. If you can spend a litle more, check out the testers by Microtest: www.microtest.com
I like their tools. A Micromapper is about $90, do the same test as above, plus a couple more. Not a bad tool for the money. If you can really splurge, check out the Microscanner at about $280. It provides the same tests, will map your cable, produce a tone for tracking with a tone probe. After that, you move into the network testers type of tool, and prices there start at about $1000.
Hope that helps.

This discussion is closed to new replies.