Discussion Locked

TIA 568-A vs 568-B

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Is there a quantitative difference between
568-A and 568-B in regards to crosstalk,
attenuation, power-sum measurements, etc?

OR

Which one is better, and why?

12 replies

by bv2

No difference - way back when AT&T devised a standard - 568-B. Then, the Electronic Industry Association/Telecommunications Industry Association (EIA/TIA) changed their minds and swapped colors. They differ only in connection sequence - that is, which color is on which pin, not in the definition of what electrical signal is on a particular color. Most uses 568-B, primarily because it has been around the longest.

by ksmith

Also don't try to mixed 568A and 568B in the same site. Use whatever standard that has already been previous used in your site.

Ken

by redshift

This is obvious. I am a network technician. The reason this question came up is because while the rest of the world uses B, the Air Force is using A. The Lieutenant that I'm working with swears that A has lower attenuation and radiation. I don'tbelieve this, and answer 1 sums up why.

by redshift

This is obvious. I am a network technician. The reason this question came up is because while the rest of the world uses B, the Air Force is using A. The Lieutenant that I'm working with swears that A has lower attenuation and radiation. I don'tbelieve this, and answer 1 sums up why.

by ksmith

Also don't try to mixed 568A and 568B in the same site. Use whatever standard that has already been previous used in your site.

Ken

by shmaltz

No difference and Stick with 568-B.
why do i say use B? b/c recently a customer called me up to install a pachpanel, pach panels are coded for 568-B (that is they have colors that work only for B) and i had a hard time changing all the jacks from Ato B.

This discussion is closed to new replies.