Discussion Locked

Token Ring Port Identification

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I currently support an old Token ring network comprimising of IBM 8250 modules.

I remember reading some where that you can run a batch file or execute a particular command from cmd prompt that would cause the activity LED on the module to continually flash for 10 seconds or so.

can anybody help?

1 reply

by mm63

Hi there,

I havent touched TR for years or the Multiprotocol intelligent hub. Normally these things came with either a diskette that contained "batch files" or you connected directly to the serial port or telneted to it in order to run the maintenance. Might have been the 8250 that you needed the "software" installed before using the console cant remember. Best bet is to try to connect up to the console port and have a look. They should have a "port" test which would make the LEDs flash to prove that they worked.

HTH

Matt

This discussion is closed to new replies.