Discussion Locked

Transfer of data from NT to Win 2000.

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

HI,
Scenario:
2 Notebooks. One on Win NT Workstation and
the other Win 2000. Both cannot connect to the network. I need to transfer data from NT notebook to the Win 2000 notebook.

My question is:
How do I go about doing it using HYPER TERMINAL or using the Direct Connection appln in WIN 2k?

Any insight into ways of doing this is most appreciated...
Thanks in advance.

9 replies

by ryder007

Hi to transfer the data quickly you'll have to be on some sort of network, wheather you connect to your LAN or you could just set up your own peer to peer. For the peer to peer just install a NIC in each and run both comps into a hub which will be very fast or you can get a null modem cable and connect the computers through the COM ports on each which is a lot slower.

Dean

by parbo

Or connect simple Peer to Peer in which case you dont need a hub. I prefer some type of network connectiona and not a direct cable connection since these are VERY slow compared to working with network cards

by sergey kovzik

"hyper terminal" is dial-up/telnet program. if you don't have modems or there is no ready TCP/IP connection - you can't. if you have modems - you can establish direct connect byt typing ATA and ATX3D in terminals, or you can even dial through phone line - ATD1234567 (your phone number here). ATA should be typen if you see RING message from modem. Then you select on one computer "Send Files" from menu and it should work.
you can try to link them via special kind of USB cable if you have USB ports on both computers. It is possible to connect using COM or LPT ports but you will need to find out some application which will work in both systems. Maybe Norton Commander or Laplink will work, havn't tested them in NT environment. If you got a network and at least one PCMCIA LAN card you can transfer everything on server and then back to second PC.

by lo

Above pretty much cover it. If you will be doing this on a frequent basis (daily, hourly, etc.), doing a network is probably the best. If you are doing a 1 shot or once a week or some such, three reasonable solutions come to mind:

1) Setup a null modem network. A serial port in this config will give you 100kbits/sec I think, maybe faster with newer hardware of today's pc. Kermit, XMODEM, YMODEM, HyperTerm, etc. should allow you to do file transfer. Do some searching on above to see what/where/how/etc. A null modem cable can be purchased from Fry's Elect, CompUSA, BestBuy, etc. for $10-$20, may need an adapter to get correct connection.

2) You can get an external Zip, Clik, etc. drive for a reasonable fee (Zip are in the $50 for an external parallel drive. Media are $10 or so per 100mb disk (there are 250mb drive/media for more $). Newer drives and media exist, higher capacity/transfer/etc. but also more $. Take a look at Iomega and compeating products from other vendors.

3) For the price of a modem and double transfer time, you can connect to any system that you have an account with (ISP, BBS, etc.) and FTP to the site with 1 system, then uploade to the other. Cost = 2 modems (one for each system, possibly 1 modem, that will work on both).

This discussion is closed to new replies.