Discussion Locked

tree or server cannot be found

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a pc that will not attach to the network. Now, that I finally have the Novell Screen and try to login it states Tree or Server cannot be found, but I see the tree and server. What could be happening?

11 replies

by steve smalley

All I can think of at the moment is to check you protocols, if your using IPX/SPX make sure it is using a particular protocol (ethernet 802.2, ethernetII, etc. NOT AUTO) I have found a number of problems occur myself when relying on auto configuration of the protocols. Try comparing the properties of the network components installed to another pc that is connected to the same hub/link.

by jimbb

A lot could be happening. As said, check protocols etc., but also the speed of your network card, don't trust the "auto" setting there either.
By the way, have you tried another network card? And I do presume you're using the latest client?
Another, tricky to find issue: do you use switches? If you have those, using IPX, make sure the "spanning tree" protocol is off.
Do you use pure IP? If there is a router between your segment and the server's that filters a bit too much, you may need to use the SLP protocol, to be configured both on your server and your workstation. To check this, try logging in into an IP address (of a NW5 server) in stead of a tree, and leave the Server field blank.
Do you use Win9x? In that case, the login screen will only come if your PC receives an answer to "Get Nearest Server". However, since browsing apparently is not possible, maybe there are some other things filtered between you and the server?
Lot of things to try, lot of things that can go wrong...
Good luck.

Jim

by estebandelatorre

You got a Login screen, that means that the connection between the server and the wks is working (cables, hub, switches ,etc..)
The main problem is in the wks's network card. Try to remove all network protocols, remove lan card and start all over again. Be sure to select the correct driver for your network card. Make it work under w95 environment (browse other win95 machines or just double click the network neiborhood)before try to install the novell client.

Good luck

by jschling

Depending on the network hardware (Cisco, 3com, etc) check the switchs for spanning tree protocal and ensure that it is set. This will cause IPX not to broadcast through the switch, you will have to configure the switch for this to happen.

This discussion is closed to new replies.