(Note: Assuming HDD already partitoned , formatted and will boot to DOS prompt)
Boot from EBD.
Select Start the computer with CDROM support.
After the computer starts.
dir c: to makesure your reading the c: drive.
md c:\windows
md c:\windows\options
md c:\windows\cabs
copy a:\himem.sys c:\windows
* following sequence is type in order. This will create a config.sys file on the harddrive to load himem.sys*
copy con c:\config.sys
device=c:\windows\himem.sys
ctrl-Z
You should seee the message 1 file(s) created.
Change to the cdrom drive, I will assume d: for this example,
and copy the cab files to the harddrive. The suggested directory is the same one usually used by OEM installs.
You don't need any of the subdirectories. The /v tells DOS to verify the file writes to the hard drive.
d:\
cd win98
copy *.* c:\windows\options\cabs /v
whe all the files are copied, remove the EBD boot floppy and the cdrom and reboot your machine.
Once the machine has rebooted to the c:> prompt.
cd\windows\options\cabs
setup
The install will run. Follow the prompts.
You WILL need your Windows 98 CDROM KEY to complete the install.
After you are done you might want to download and install the
UNOFFICIAL Windows98 Second Edition Service Pack 2.1a (Freeware)
http://exuberant.ms11.net/98sesp.html