Discussion Locked

Two VPN Problems

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

VPN server, NT4.0 sp6a , pentium 3 500mhz 256MB, running RAS and PPTP, also runs MSSQL7.0. SQL services used mainly during the day and VPN services used mainly at night, rarely are both services doing anything at the same time. Network is on a T1 with a cisco 2500 series router.
One user is using win2k with a T1 at his end (don?t know anything else about his network). When first setup everything worked fine, connection stable and fast. Over time the connection became unstable, will disconnect in the middle of a session for no apparent reason. Can reconnect and work for a little while then disconnects again. Has gotten to the point that he can't use it at all. Server appears to be running fine, no unusual memory or cpu usage, nothing showing up in event logs, no problems with SQL....
So my first question is, any idea what?s going on or what I can monitor on the server to diagnose the situation?
Second user has win ME over a starband two way satellite. Satellite works fine with http or ftp connections, averaging about 800kBps on a good day. VPN connection BLAZES at about 8kBps.
So my second question is, any idea why VPN would be 100 times slower over a satellite connection and can anything be done about it?

9 replies

by gmak

Q1 - You need to get more info about his side of the network to assess the situation. Sounds like there is some major network conjestion on one of the routers involved.

Q2 - VPN traffic is going to slow on most connections due to the authenication. I have seen many timeouts with Raptor VPN's with each side having a T1 connection to the internet.

by stillatit

What may be happening is that your user's computer and/or network router is acquiring a variety of routes to your sql server, only one of which is the correct vpn route. Try having him print his route table (ROUTE PRINT) and see if there are any extra routes. Also try having him put an explicit static route for your sql server pointing at his vpn.

On the satellite issue, a vpn has some degree of synchronous behavior built into it. I suspect there are some points where the sender waits for a response such as to a heartbeat request, and this would wait for the earth-satellite-earth speed-of-light time.

Microsoft says it does not work at all. See Knolege base article Q239109 at http://support.microsoft.com/support/kb/articles/Q239/1/09.ASP
(remove any spaces in the above url)

Good luck.

by mckaytech

The first one sounds like a problem with the T1 line bouncing rather than a server problem.

The second one sounds like a problem with the latency inherant in satellite connections.

In either case, the best troubleshooting is going to come from doing packet capture and analysis and involving the service providers who supply the circuits.

paul

by estebandelatorre

1.- Seems to be a congestion traffic. If you have a Netware 4.11 or +, try it?s ping utility. It can give you a quick snapshot of what is happening, bringing in a single line ot text average, packet send and receive, best & worst time, and a Trend.
2.- It?s normal satellite connection time depends on "sky status". Try it on a rainy day, it?s almost imposible!

edt@bancobgn.com

This discussion is closed to new replies.