Discussion Locked

Unable to connect to DSL Modem.

0 helpful
22 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have the AT&T DSL service with a Broadxent 8012V modem. I used to get the internet directly through the modem until I got another computer. Now both my computers are connected through a Linksys BEFSR41v4 router. I used to connect directly to the modem but now I cannot. I do can connect through the router, but when connected directly to the modem it says the The Remote Access server is not responding.

22 replies

by master3bs

I don't have the specs on that modem handy and don't have time right now to look it up. However, what is preventing you from connecting to the modem is you are pulling a linksys ip address. You can probably surf into the linksys by going to 192.168.1.1 from Internet Explorer.

Are you needing to access modem options while connected to the router? There are some options.

1. adjust the settings while not connected to the router
2. see if it is possible to set the router to bridged mode, or to do an ip passthrough on the router.
3. do step 2 for the dsl modem if step 2 does not work or is not available.

by yargls

I know that there are some Westel modems where you've got to do the equivalent if ipconfig /release before it will serve an IP to a different device.

Could be you've got to go into your router and go into the WAN status window (or the equivalent) and get it to release the ip before you can connect your PC directly again.

Is your connection PPPoE?

--yargls.

by thechas

I recommend that you give Linksys customer support a call.

While the setup instructions work for most DSL connections, sometimes you need to adjust the setup just a touch for specific modems and providers.

Tech support at Linksys is very good. (At least they were for me a couple of years ago.)

I have also been told that AT&T DSL may not connect if you have a router firewall enabled.

Chas

by swlchris

Hi
Try resetting the dsl modem, clear out the previous settings, then use the router to see if you can push through the modem and connect that way, It might help who knows,
Had verizon DSL here , but their modems came with a built-in router,got cable internet after that, had to tinker with the cable modem to get it to work with the router which was a netgear, but it all works now.

by blegend

The router has no problem connecting and I resetted the modem. The lights on the modem shows there is a connection but something screws up the communication between the modem and my computer.

by blegend

I use a BitTorrent Client and for it to access the internet, I need to connect the modem directly to the computer avoiding the router. It was fine till the last couple of weeks. But now the modem cannot connect to the remote server. I tried to reinstall the modem's software but I cannot complete it since the modem should connect to the ISP provider directly.

by yargls

When you connect via the modem, can you surf, or is your problem strickly with BitTorrent?

If the problem is with BitTorrent, I'm betting you've got a new or reconfigured firewall that's causing your problem. The linksys has a firewall integrated in it and that firewall is probobly the reason you can't use BitTorrent when connected through it.

If you can't surf when you're directly connected to the router, then I'm back to my assumption that you need to have the router release the ip before you can connect directly to the modem, either that or you haven't reconfigured your network connection to work with PPPoE when connecting directly to the modem.

--yargls.

by blegend

No, when I connect through modem I cannot surf the web. Can you help me to get my router to release the ip.

by yargls

I'm assuming you've only made enough changes to the router to use your PPPoE connection.

In your browser window, go to 192.168.1.1
In the loging box type admin the password is password (unless you changed it of course).

Go to the Status tab.

There you will see a DHCP release and DHCP renew. Click the DHCP release button. Hopefully that will do it.

A couple other things.

-You can probobly make BitTorrent work through the router via some port forwarding, but I don't have the specifics on that.

-You will need to type the following in a command windows after you're finished using the laptop directly on the modem

ipconfig /release

-You ought to change the default password on the router just to be safe.

--yarlgs.

by blegend

My connection is PPPoE and the router says "If your connection is DHCP or Static IP, the DHCP Release and DHCP Renew will be available to release and renew an IP address from the Internet connection." So should I change my connection to Static IP?

by yargls

No, don't setup a static IP unless your ISP has given you one to use.

If you've got a static from your ISP, then you need to use it when you directly connect your laptop to the modem.

--yargls.

by blegend

But with PPPoE my router's setup page does not show any option to release/renew my IP address.

by yargls

Look for a STATUS tab, it'll be one of the tabs across the top of your page. If you're looking on Setup, you're not going to see the DHCP Release button.

--yargls.

by yargls

Then I would click "disconnect" and try connecting with your laptop.

--yarlgs.

by yargls

Not sure we're both on the same sheet here.

I realize you don't have a problem connecting through the router, that's why I wanted you to disconnect the router from the service before you connect with your laptop. Do not reconnect with your router before connecting with your laptop via your modem.

If you didn't reconnect with your router and you're still getting that error, then either your PPPoE connection via your laptop isn't configured correctly, or you had to configure the modem to allow for a passthrough (or bridged) connection in order for it to work with your router. I don't know enough about that modem to lead you through changing that back and forth.

I expect you have (or had) a connection icon you had to click before you could connect to the internet (before you got the router). Either that's gone, is mis-configured (did you change your AT&T password?) or the modem won't let you connect directly until you disconnect via the router.

Your other option is to make BitTorrent work through your router. I'm reasonably sure that you've just got to do some port forwarding and you'll be able to use it via your router.

--yargls.

by blegend

Yea, I think my modem won't let me connect directly until you disconnect via the router. I tried to make BitTorrent work through my router by port forwarding and it works thanks for the help.

This discussion is closed to new replies.