Question Locked

Unable to connect to natted public IP on same network behind pix

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a situation that I would normally resolve by setting up fake internal DNS zones that resolve to the private IP, but in this case it isn't an option. So I need to know if it is possible (feaseable or a bad idea) to connect to the natted public IP of a server from another system on its same network.

Here is a brief example:

Server
10.5.10.100 nat to 66.xx.xx.70
port 80,443 exposed on fw

Admin workstation on same subnet
10.5.10.150

Cannot hit 66.xx.xx.70 from 10.5.10.150

Firewall logs show a built connection, but no traffic ever flows.

Any suggestions would be appreciated.

3 replies

by cmiller5400

Have you tried sniffing the traffic to see where it is failing? Wireshark is a good one if you don't have a sniffer.

by mike.bullock

It seems to be an implementation issue with the pix firewall because all of the numerous systems on that network exhibit the same behaviour as my previous example.

I guess my question remains, can it be done. I just haven't seen a post out there that mirrors the situation, but I'm sure someone has run into it.

This discussion is closed to new replies.