Discussion Locked

Unable to initialize the NLM connection

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have two very similar Netware 4.11 servers on the same NDS tree, both running BE 7.11d. I rebooted the servers. One server is fine, the other does not load BEMGR.NLM. I receive the error "Unable to initialize the NLM connection" Does anyone have any suggestions?

Thanks,
AAB

5 replies

by papachuck

There are two other documents on Veritas site ....189014.htm and 188873.htm Both deal with the use of dsrepair and XK3 ....Be sure your master NDS server is error free...use dsrepair until no errors and be sure your servers are communicating with each other and the NDS is communicating with all the servers on the network...Also your R/W NDS servers should have no errors....also between changes give NDS time to get the information out to the other NDS servers. Can take over a hour for info to filter to all servers in a large network.
Also before you begin on one server do a DSmaint and prepare the server for a hardware upgrade...This will put a backup of your NDS on a drive of your chioce. You then can reload the nds from the same screen and continue on as normal and have a backup on another drive....Just to be safe.....Good Luck...I know from experiance if NDS crashes what a pain it can be to get back.... spent 22 hours on phone with tech support to get our NDS back after a crash....Also if you have any Aliases on your NDS delete them if you can before updating and dsrepairing...aliases can stop the dsrepair process....you can always recreate them after the dsrepair process is done.....Chuck

This discussion is closed to new replies.