Discussion Locked

Unable to pass the parameter from CMD file to REXX file

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Currently, I am involved in a migration project (from 2000 to 2008) which has CICS, COBOL and Object rexx and it is on windows 2000 server which is working fine. When I Install the same softwares I am not able to pass the parameter with the command file to a rexx file in windows 2008. I have tested by providing a hard coded (giving parameters in the Rexx file) and it is working fine.
Is there any difference with Command line arguements ? or Scripting ?
Because of this issue we are not able to proceed further... Suggestions are appreciated..
Thx.
Raj

1 reply

by Wizard57M-TR

Try re-posting in the Q&A
section.The 'Discussion' forum is for matters of general discussion, not specific problems in search of a solution. The 'Water Cooler' is for non-technical discussions. You can submit a question to 'Q&A' here:

https://www.techrepublic.com/forum/questions/post?tag=mantle_skin;content

There are TR members who specifically seek out problems in need of a solution. Although there is some overlap between the forums, you'll find more of those members in 'Q&A' than in 'Discussions' or 'Water Cooler'.

Be sure to use the voting buttons to provide your feedback. Voting a '+' does not necessarily mean that a given response contained the complete solution to your problem, but that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours. If they have a ready source of reference available, perhaps won't need to repeat questions previously asked and answered. If a post did contain the solution to your problem, you can also close the question by marking the helpful post as "The Answer". .

This discussion is closed to new replies.