Discussion Locked

understanding 0f break down of subnet

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
any good sites or docs on how to break down subnets. I could use a little help on that subject.

3 replies

by czinke

go to www.webopedia.com and type in subnet mask. They give a brief description of what it is but at the bottom they give additional links for subnetting. Cramsession.com had a couple of good articles on subnetting a few weeks ago on their site but Idon't know if they are still there.

by csilveira

This on is a little hard to read but may give you the info you need to figure it out for yourself. in a nutshell convert your mask to binary. valid masks will have all 1's followed by 0's. Not 1's and 0's interspersed. Now take your prospective IP address, convert it to binary and write it down. next copy your Mask directly under the IP address. now start a new row and lable it "Network Number". Now one column at a time if the mask has a 1 copy the IP address, if the mask has a 0 copy a 0 in that column. label a new row "Broadcast Address". Now one column at a time if the mask has a 1 copy the IP address, if the mask has a 0 copy a 1 in that column. Convert the Network Number and Broadcast address back to decimal and the usable host addresss fall "BETWEEN" these addresses. mask 255.255.255.{252,248,240,224,192,128,0} will corelate to {2,6,14,30,62,126,254} Hosts

this document was written to explain someting else but it might help some.
http://www.cisco.com/univercd/cc/td/doc/cisintwk/idg4/nd20a.htm

This discussion is closed to new replies.