Discussion Locked

Upgrade to 5.0

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Anybody out there know if there are any issues with GroupWise 55 EP SP1 when you upgrade the server from 411 to 5?

5 replies

by bchesmer

The only thing I could find for u is in TID 2956734, on novell's support site. The only oter info I can give u is to make sure your 4.11 is up to date wit te most current SP before your upgrade. Also, check on your specific harware drivers for your server before the upgrade.

"2.4 GroupWise WebAccess and WebSphere

When WebSphere is installed, it will configure the
NetWare Enterprise Web Server to direct any URL request containing http://hostname/"servlet" to
WebSphere. Note that GroupWise WebAccess, when installed,
will ensure that the "servlet" tag is configured to the Novell Servlet Gateway, the default
servlet engine for WebAccess.

Because both of these products compete for the "servlet" tag, GroupWise WebAccess cannot currently
use the Novell Servlet Gateway for the servlet
engine while WebSphere is also configured on the server.
To avoid this problem, you must either move WebAccess
to another server or configure WebSphere to be the
servlet engine during the WebAccess install."

by acurrin

1st answer would only relate to NW 5.1.

We have run on both servers without problems. The GroupWise NLMs are (thankfully)pretty much independent of NetWare, so you should have a clean upgrade.

The only enhancement pack issue we have had was upgrading the NT WebAccess gateway on IIS. We ended up moving it to a different server.

Good Luck

This discussion is closed to new replies.