Discussion Locked

Upgrading 10BaseT to 100BaseT

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all!
The 30+ bodied company that I work for has asked be to look into upgrading both our internet and LAN connections...
we have a 10BaseT Ethernet that is NOT handling traffic optimally. I was just wondering if anyone could shed some light on what I need to do to perform the upgrade and also might have an idea of a "cost" factor. From what I understand, I need to make sure all the hubs/routers/NICs are 10/100BaseT and the speed should take care of itself.
Anything else I need to be doing?

Thanks

Jefff

4 replies

by dlwenger

Don't forget to check your wiring. If you're not using well installed category-5 wire your're probably going to be losing quite a bit of that new bandwidth in kinks and badly terminated connectors. Be sure to check patch cables from the wall to the computer too. They often get abused during their lifetime.

by wpteh

Dlwenger and Chris are right about using CAT 5 wiring for 100BT capabilities.

But often, one will neglect the actual category of wire that was pulled in-wall. *from the patch panel to the network socket on the wall* Changing just the cable from the patch panel to hubs or the one from the PC to the network socket will not assure a 100%.

You can check with the contractor who is in-charge of all the in-wall cabling and make sure that they are CAT 5 too.

Good luck.

5mm.
Singapore.

by jackieb

Another way to check is with a decent quality Cat5 cable tester. This can be used to ensure your cabling is up to the required standards to handle 100Mb Ethernet. A lot of older buildings have Cat3 cabling in the walls which will not pass 100Mb requierments, and homemade patch cables sometimes will not pass. Also, just using Cat5 cables does not ensure you are 100Mb capable, the cable has to be terminated properly with Cat5 connectors to pass the requirements for 100Mb. If a good quality cable tester says you pass the requirements for 100Mb, then you will probably be ok as far as the cable plant is concerned. Then all you have to make sure of is if all the nic's and hubs/switches are 100Mb (or 10/100). Jackie

This discussion is closed to new replies.