Discussion Locked

Upgrading to Dual Processor - Reinstall

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am upgrading my Compaq NT 4.0 SP5 to a dual processor. I am going to try using UPTOMP from the resource kit.

The server is running Exchange 5.5 SP3. Do I need to reinstall any or all of Exchange after upgrading besides maybe reapplying the SP ?
Has anyone used the UPTOMP ? Any warning hints or help would be much appreciated.
Thanks !

12 replies

by mcessna

I have personally never had good luck with the uptomp utillity. The couple of times I have tried to use it I encountered problems. I have found that rebuilding the machine from scratch a much better option. I understand that a production server may not be able to be down that long but hopefully that's not the case with your server.

by lisa_rogers0997

Thanks for the feedback.. Head Office didn't want to do the reinstall, they thought the utility would save some time.
This is a new, not in production yet server, so I would much rather do something I know will be clean.
Thanks again !

by lisa_rogers0997

Thanks for the feedback.. Head Office didn't want to do the reinstall, they thought the utility would save some time.
This is a new, not in production yet server, so I would much rather do something I know will be clean.
Thanks again !

by lisa_rogers0997

Thanks for the feedback.. Head Office didn't want to do the reinstall, they thought the utility would save some time.
This is a new, not in production yet server, so I would much rather do something I know will be clean.
Thanks again !

by aekland

Since it is a compaq, I would use the NT SSD that can be found on there website. If you haven't used it, it is a utility for installing compaq drivers and such. In it there is a multiproccesor upgrade, the top selection I think, just click on it. I think it asks for the nt disk or the Service Pack files for the MP Hal files, reboot and you are all done. There is also a recovery option that gives the option to load as a single processor machine if needed. Used it several time without any problems.
SP are always good to reapply after changes but shouldn't be needed.

by lisa_rogers0997

Thanks for the feedback I will try Compaq's utility. The server's not in production yet, so if all fails I can rebuild.

by lisa_rogers0997

Thanks for the feedback I will try Compaq's utility. The server's not in production yet, so if all fails I can rebuild.

by lisa_rogers0997

Thanks for the feedback I will try Compaq's utility. The server's not in production yet, so if all fails I can rebuild.

by bggb29

I have used both uptomp and the compaq ssd. The compaq stuff works great. Uptomp had failed on me twice using dell servers. Had to manually install, lucky i had fat partitions.
Reapply the service paks after the ssd.

by lisa_rogers0997

Thanks for the feedback I will try Compaq's utility. The server's not in production yet, so if all fails I can rebuild.

by lisa_rogers0997

Thanks for the feedback I will try Compaq's utility. The server's not in production yet, so if all fails I can rebuild.

by lisa_rogers0997

Thanks for the feedback I will try Compaq's utility. The server's not in production yet, so if all fails I can rebuild.

This discussion is closed to new replies.