Discussion Locked

Upgrading to P4 Cpu

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently upgraded a clients PC, from a P3 to a P4, and now the pc will not boot. What could be the problem?

13 replies

by zlitocook

You need to give us more info. Like did you just put new computers in and expect them to work like the old computers? Did you migrate the old settings to the new computer, how did you move the users to the new computers? What O/S was the old system? Win98, 2000 and did you save the user files to a system a back up or system share?
Please tell us what they were using before the upgrade and what you are using now.

by valis

need FARRRRR more information than this.

what did you do, just pull out the p3 and plunk in a p4?

by matrat

I replaced the motherboard, and Cpu.
The system was running Win Xp SP2.
It won't boot even when I put the old board and chip back in.

by saihib

P4 motherboards have 2 electrical connectors on them. Besides a new motherboard and chip you also need a new power supply.

by willcomp

Expound on what you mean by won't boot. How far does the bootup process go? Can you enter BIOS setup? Any screen activity? Any beeps? Does Win XP start to load?

by thechas

Changing the motherboard can cause XP to not boot.

After attempting to boot with the new motherboard, you have XP very confused as to what hardware it is attempting to use.

You will need to boot from the XP CD and perform a repair installation.

Or, start over installing XP onto a formatted hard drive and use the files and settings wizard to transfer the user data off of this drive.

Chas

This discussion is closed to new replies.