10 replies
by tbradley
I assume you're talking about hubs and switches.
An uplink between 2 hubs is simply a cat5 or fiber connection. It is the least effective way to connect the two. A hub divides linespeed ( ie 10 mps or 100mps ) between all
of its ports. Say youhave a 10mps 4 port hub. Each port is technically capable of 2.5mps line speed. Now if you uplink a 2nd 4 port hub, the second hub, even though 10mps, is limited to the 2.5 mps, and only 3 of the ports are free.
Hub1 ( 10 mps ) Hub2 ( 10mps )
P1 P2 P3 P4---2.5---P1 P2 P3 P4
2.5 2.5 2.5 X X .83 .83 .83
You can go up to 4 Hubs deep, but as you can see, it's a law of diminishing returns.
The Stackable feature uses a matrix module or a transceiver module to connect the two, at or greater than line speed, and doesn't use a port.
Hub 1 ( 10mps ) Hub 2 ( 10mps )
P1 P2 P3 P4 xxxxxxxx P1 P2 P3 P4
2.5 2.5 2.5 2.5 10mps 2.5 2.5 2.5 2.5
Of course, this is more expensive, but when performance outweighs cost.....
The principle works the same with switches, tho the switch does not share bandwidth. Each
port is 10 or 100mps full line speed. A hidden feature of switches are their internal speed, for a high quality switch, this is over a gigabyte, and a matrix module will extend that bandwidth to the second switch.
by tknorris
by vwalton
by tknorris
All answers here are appropriate but, I'd like to add a little clarity to the matrix type of cable connection.
As stated earlier, the uplink port simply daisy-chains two devices together. This is a very popular way to place hubs and/or switches in closets and aggregate traffic back to a core switch, etc. This practice burns a port on both devices and is limited to the Ethernet specification of the port (10Mbps or 100Mpbs, normal or full duplex).
Matrix cables, on the other hand, are designed by the device manufacturer to support specific functions that are unique to that device and are NOT limited to Ethernet speeds. For example, the matrix cables that 3Com provides for their SuperStack line of hubs and switches extends the physicalbackplane of the "master" device to the "slave" devices. This effectively creates a multiplying of ports across a very high speed backplane that is capable of gigabits of bandwidth. Think of the matrix cable as being able to extend the bus of the switch to another switch.
Also, the use of matrix cables typically extends proprietary management features of one device to many devices. The use of a management module in the "master" device allows all of the matrix connected devices to be managed as well.
My advice: use the matrix cable whenever practical.
by tknorris
by vinodgupt
Uplink - The uplink is nothing it is only the cross connection of the UTP cable. so here, there is no electronic device, the Trans wires are connected to the recev wires. It also increase the hop counts and incrase the collision rates. Thru this it can be connected upto 100 mtrs.
Stackble - This is the integrated circuit on the Hub/switch backplanewhere the another hub/switch is connected. Both the devices behaves like the single hub/switch. and there is no increase of hop counts. Max you can contact around 8 devices so that you get the high port density. Also it has to be connected with small cables. most of the stack cable comes with the length of around .3 to .6 meters. It is a best for Centalized networking.
by tknorris
by tknorris
by tknorris
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending