Question Locked

USB ports don't recognize anything pluggd in

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

On an HP Pavilion Notebook dv8301nr with WinXP SP3 update

At one point we tried to install the Microsoft LifeCam NX-6000 camera and the installation failed. After that we were unable to uninstall satisfactorily and two of the four USB ports stopped beeping and responding.

Our initial suggestion was to uninstall the USB ports in Device Manager and have the system reinstall. They seem to reinstall okay, but now none of the four USB ports work.

Every time I boot up the machine it tries to install device drivers for two "unknown" devices in the Device Manager. If I click locate drivers it just goes to limbo until I cancel the install.

I cannot see any USB devices (used to have an HP Camera) on the "My Computer" selection. I ran Driver Whiz and it recognizes the MS LifeCam as missing drivers as well as other device no longer on the system

I would much prefer not to have reinstall WINXP altogether. I need to find out if and how uninstalling USB drivers completely and reinstalling them will help fix the problem.

4 replies

by oh smeg

But I would start off with Opening the Device Manager and deleting all the USB Hubs and so forth. Then restart the system and allow Windows to load the required Drivers.

Yes I know you may have done this previously but as they are not all reconnected you should repeat the process.

If that doesn't work you can try a Repair/In Place Install by following the directions here

http://support.microsoft.com/kb/978788

These would most likely be the easiest way forward here at the moment. ;)

Col

by joskin

Thank you for your reply. No the USB ports are not beeping anymore.

This discussion is closed to new replies.