7 replies
by gbjoe
Do you have IP connectivity to the proxy ? If not, well that's your problem right there. If you do have connectivity then I suggest you make sure you have added the subnets of all offices to the LAT table (in the Winsock or WebProxy properties). Also make sure that all necessary users have permission.
hope this helps
by rbarnette
by stillatit
Is this a hard-wired (or frame-relay) wan that is now working, or are you just designing it? (Design phase is beyond the scope of this answer.)
If it is a working WAN, remove the WinProxy and make sure that all stations can ping all other stations. If they cannot, you have a router problem, which you need to solve before you can use a Proxy.
Using Winproxy involves running it on a machine which is connected both to your LAN and to the internet. To browse, a station must have the IP address of your WinProxy machine in its browser Proxy settings (In IE5.5 this is Tools/Internet Options/Connections/LAN settings/Proxy Server). To send mail (SMTP) to a mail server behind your WinProxy box, the outside station must use the internet address of the WinProxy box, not the mail server, and WinProxy must be configured to pass SMTP to the real mail server.
Good luck.
by rbarnette
by epiemuird
I had a similar problem - all of my users at the main site could reach the proxy server but no one in the outlying sites. I ended up setting up a new domain just for proxy and put proxy on the pdc and created a group account for the users at the outlying sites. I configured their ie for the ip address of the new proxy server. They were then able to use proxy to access the internet. I had to enter the ip address for the remote sites into the route table on the proxy server using the route ADD-P command.
The main thing was that proxy had to be on the pdc.
by rbarnette
by rbarnette
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending