Discussion Locked

Validating Users

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I want to connect up to 3 laptops running Win 95 to a 3Com Office Connect 56k lan modem dialing into my Win NT 4 RAS. I have the 3Com configured with a valid user and password. My problem is when I logon from any of the laptops. I get unable to finddomain to validate user. I followed the defaults from 3Com. What am I doing wrong?

6 replies

by dan_hammock

Do you have the correct DNS, WINS and gateway set on the laptops? Are you able to access other network resources or do you get disconnected?

by mjervis

Make sure your network settings are correct wins, dns, ip addressing, workgroup name and domain name. Also make sure your subnet is right we had the same problem when I looked over the configuration it was just a wrong subnet.

To check your ip address and subnet in win9x use run > winipcfg

by ihshaikh

try pinging you NT server, it you do not get a reply, then your ip add, subnet, gateway, must be incorrect.

if you can ping then your network settings, wins, dns, domain should be looked into.

This discussion is closed to new replies.