Discussion Locked

Video Problems

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I went out on a call yesterday with a guy who's computer wouldnt boot up in win98. I SYS C: 'd him with a boot disk and it was fixed. However when it boots into win98 video won't go past 16 colors and the resolution won't go past 640 X 480. Everytime I set it higher, the system reboots and when it starts windows there's nothing but a black screen.

To fix it I have to go into safe mode, set the adapter to default and its fixed but it's fixed at 16 colors and the same res.

Any suggestions on how to fix this?

4 replies

by mckaytech

There are likely possibilities.

The first, and most likely, is that the video card is not being properly detected and the wrong driver is being installed. For this problem, get the hardware information on the video card (or video chipset if embedded on the motherboard) and get fresh drivers from the manufacturer's Web site.

The second is that the video card just won't support higher resolutions. The solution for this is replacement of the video card.

paul

by eltoncole

The video hardware obviously isn't the problem. If it were, safe mode wouldn't even work.

by brugge

There might be a lot of different possebilities. The driver is the most likely one. Second one can be the memory on the videocard. If that went bad, it is no longer able to go into high res. If the video adapter is onboard, make sure it shares enough memory. also make sure that the synchronization frequency is at least 60 Hz. Below that it won't go into highres either. If the monitor itself went bad, or was replaced with a VGA in stead of SVGA monitor, the same problem might arise. As you say that you had to SYS the hard drive, it appears that some software went bad. The videodriver itself could just be replaced with the original and it could solve the problem.

This discussion is closed to new replies.