Discussion Locked

Virtual Memory

0 helpful
18 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have a Windows NT Server 4.0 with Service Pack 4 and has 256MB memory, (2) 4.3GB SCSI Hard Drives Mirrored, A/Open 10/100 325 Network Adapter. The system keeps giving us the following message:
"System is running low on virtual memory"
I've adjusted the virtual memory setting and it's set at the proper value based on 256MB memory. What's up?

18 replies

by david

Are you running SQL server or is the server a DNS server? If it is a DNS server, check out this article. Q182713. The other article I have does not have a number but it says if you are running SQL server to set the virtual memory at 1.5 times thephysical memory. Good Luck.
David

by rstencel

The 1st answerer has a good point. The recommend setting for cache is a baseline. It doesn't always take into account all the software you may be running on your system. If you are running a lot of apps or have a lot of clients accessing your server this may not be enough. The role you set for your server also affects the way memory is used and how much you need to set up. Basically the more applications and users you have running the more virtual memory you will need.

by ustutz

Categorically set virtual memory to twice RAM without thinking twice. Depending on workload and diskspace available, three times RAM may not be outlandish. Also, on the virtual memory configuration screen you have two parameters: Initial Size andMaximum Size. Set both to the same value (i.e., the "maximum size").

by a.douwes

You can determain the amount of physical memory needen by adding all the memory specifications of the applications you will run concurrently. Have you checked with the TaskManager to see which application is consuming so much memory?
Does NT do themirroring or do you have a RAID-controler doing the mirroring? If NT does the mirroring it could wel be the cause of low virtual memory. Have you checked out the fixes of SP 5 and SP6a conserning memory leeks?

by jp.jacoby

The allowed minimum is the Phys. size + the size of the registry. Means here: 256 + 16MB. (+/- 16MB you have to check how big it is the registry is).
Anyway, depending of the software you use Exchange, Sql, Proxy.... set the minimum at 300 MB and the maximum at 512 Mb for the virtual memory. Better more than less if you have enough disk space.

jpj

by jieyu

hi check in control panel-> system->preformed-> check you virtual memory is hight or low if is low you ust change to at least 256mb.if you stil have the erro message you need check you solfware i think one of you solfware is crach.

by coolkid1111

Sometimes if you're running memory-intensive programs, the suggested amount just isn't enough. There could be some bug, I don't know, but try giving VM an extra 50-100MB. That should work!

Hope this Helps!
Eric Frazer

by jbroelfs

If there's a virusscanner active on the server you could kill it or at least make sure it doesnt check every incoming file. This will not only make the server slow it also uses lots of memory.
Good luck!

This discussion is closed to new replies.