Question Locked

Vista SPR-Problem " Computer can't hear anything"

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Vista loaded on ACER Aspire 3054
When I try to use speech recognition, i get message " Computer can't hear anything"
when using built in microphone or external microphone
Can you help please
Thanks
James
attreejc@absamail.co.za

8 replies

by menzo

Did you complete the Mic. Test in the Sounds Options of your control pannel ?

If your mic can't be hear in the test, you should check your sounds drivers and/or check on your sound control if your Mic. is not checked as "Muted"

by semajc

Sound drivers checked ok
Sound control checked -not muted
Is there a way to test if mic connections to sound card are working?
Thanks
James

by older mycroft

Then select AUDIO Properties.

You'll find the slider for the microphone may be too low. The little box is probably 'ticked' - muting the microphone.

Untick the box and adjust the microphone level to suit.

by semajc

Drivers checked ok
Audio properties checked not muted
Sound levels - even when set to max computer "still can't hear"
Is there a way to check mic connections for recording
Play back of CD/DVd no problem but I can't record anthing.
Thanks
James

by tedc

I had the same problem, which would happen after using vista's mic setup - the setup was turning my mic down so far that the rest of speech recognition could not hear it. Apparently it was turning down the loud hissing of my sound card (when set to +30 db boost). A cure for me would have been: use a modest mic amplication (done by a mic pre-amp instead of the sound card's boost). This would have had much lower noise, left at ok volume by mic setup. But I gave up at this point, after trying (and taking back) several mics.

by semajc

not only can't use vistaspeech recognition, I also can't record anything whether using built in or external mic
Playback of CD or DVD is fine

Can you record anything
Is there a way to check that mic connections/sound card is working for recording
Thanks
james

by forerunner

ok all of you my not know this but vista has taken direct sound out of the kurnal and will no longer let the sound card & direct sound talk to each other. i had the same problem it tured out that this was my problem the sound cards that are going to full work need to be ony a few months old and say that their vista compatible.

or you will get something like the mike will not hear you at all or be very low. even with a new sound card it was still a bit tricky to get it to work with my mic

This discussion is closed to new replies.