Discussion Locked

VPN

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
This is actually more of a CISCO question. I am trying to set up a VPN solution using Windows 2000 - which is inside of the firewall. How do I configure a conduit on the PIX 515 running software ver 4.4(1) so that clients can access the server?

6 replies

by qb

You have to map a legal ip to the VPN box IP with the right port number(s), (will very depending on the vpn authentication used). I hope you have an extra IP because PIX will only map one external to one internal unlike nat where you can map one external to many internals based on port numbers. You can open all ports to the vpn in that mapping for testing but I would defiinatly figure out what ports you really need so that you can lock it down. By the way I know IPSEC doesn't work through NAT but I not sure about PIX (which Uses PAT, port address traslation). You might want to look into that too.

by ann777

We had to upgrade our PIX OS before we could get any Windows-based VPN to work.

Cisco's VPN Client And Server is probably the only VPN that will be supported with 4.4

This discussion is closed to new replies.