Discussion Locked

VPN, Frame Backup, and Firewall-1

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

In an othersise Cisco shop, I have a Firewall-1 on Sun and have a variety of frame relay connections to it. These frames connect to other company sites, and from a firewall perspective we treat those sites as insecure as they may have connections to the Internet that we do not control.

So as backup for the frame connections, why not use VPN instead of more traditional ISDN dial-up? (Not so fast - that's a rhetorical question.)

The REAL question is: HOW? Will FW1 do automatic failoverto the VPN? I understand Cisco routers can, but our VPN's are Check Point at the moment.

400 points for good info... thanks...

4 replies

by networker4

I have a Checkpoint FW in the US and one in Japan. There is a VPN set up between the two. I also have a frame relay connection between these sites and use the VPN strictly as a backup.

Now you want to know how, huh? Well, okay. It's just how the routing works. At both sites, the routers point to the firewall as their default route. As long as the frame relay connection is up, the routers are exchanging routing information and using the frame link. As soon as the frame link goes away, the routers age out the routing information and start sending packets destined for the other end to the default destination - the firewall. The firewall recognizes that this is traffic destined for the VPN based on destination address. You could dothis of course even if the firewall wasn't your default route. Just put a static entry into your router with a higher metric than the frame connection. This may help with router convergence time too.

This discussion is closed to new replies.