13 replies
by hayoubee
It is abvouse hier that the configuration of the router is not good,Look in the configuration interface of the router self ,and in the DHCP server on the server.
1-you have to configure the Modem of the ADSL (I think you have doen this bcz you haveinternet connection).2-configure the Router with the good vlues and parometer for ip adress and dns ip adreses .3-in the dhcp server you have to add the(router and DNS server)as the folowing,from DHCP option :scope with their values (ip adreses).
and be sure it will work
success
by awjackson
by liquidcoolit
Firstly you cannot have 2 IP's on a network that are the same. VPN is just a form of tunneling to your network from the internet or any other external/internal source.
If you want to Share an internet connection you can use Win2k's built in Internet connection sharing, that basically implements NAT technology. So you can have multiple PC's on a network using a single dial up to the internet.
Artical - Q237254 - How to Enable Internet Connection Sharing on a Network Connection, on Microsoft technets Knowledgebase explains in detail how it works and how to set it up.
Cheers ....
by awjackson
by zen37
You question is vague, can you supply more information by answering the following;
>What model of Linksys are you using?
>Are you using the PPPoE Access Manager from the Linksys or is it an application on your server/workstation?
>What kind of connection are you attempting to do your test (HTTP)?
>Did you check your DHCP configuration on the Linksys?
>Did you check the DHCP information you got (on your server/workstation) from the Linksys?
If you answer these, i may get a better pictureof your problem and will be able to offer a better solution.
Waiting for your reply.
by awjackson
by mckaytech
The Linksys DSL router has somewhat limited functionality so I can't say for sure for your particular setup, but it is possible (with the right equipment) to use one external IP address to support multiple inbound VPN connections and is particularlyeasy when the VPN tunnel terminates on the router itself.
In that case, you just use NAT and an IP address pool and everything is peachy.
If it turns out that this is not supported by the Linksys router, you might want to consider putting anold P100 computer into service as a Linux router with IPSec support. This can do exactly what you want with very little cost other than some configuration and tweaking time and the available support has been excellent. You can find more info at leaf.sourceforge.net
paul
by awjackson
by zen37
I'm sorry, misread the original question. I found the following in the DSL/Cable Modem router user guide, it may provide you with an answer;
"from multicasting. Using IPSec Pass Through
? This feature lets you use IPSec Pass Through. To use this feature, click on the
IP Filters block specific internal users from accessing the Internet and enable
VPN (Virtual Private Network) sessions. You can set up filters by using IP
addresses or network port numbers (or a range of ports).
Note: : Only oneVPN session may be conducted at a time."
Good luck
by awjackson
by choppit
by awjackson
by awjackson
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending