Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I remember reading somewhere that you can run VREPAIR on the SYS volume but I don't remember where or how. Do you know?
3 replies
by paul.gerth
You can run vrepair on any volume as long as it isn't mounted. Make sure everyone is logged out and any apps that might use Sys: are unloaded , load vrepair , dismount the sys: volume , run vrepair on it until there are no errors , re-mount sys: . Iusually restart the server . You didn't say what version of NW but NW5 will run vrepair automatically if there are any problems .
---paulg
by scrounge1
It worked, I remembered after I started reading this. Someone once told me you can't unmount the SYS volume. I think they must have meant without the server going off line.
Thanks...Gary
by scrounge1
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies