5 replies
by bfilmfan
by sgt_shultz
ya don't need strong scsi experience, ya need strong ibm experience.
i bet you 20 bucks if you edit the boot.ini file on your ibm server to indicate NON scsi adapter, it will boot. do you have an old copy of the boot.ini to look at?
did you try another scsi adapter
by cg it
yeah but boot order in the BIOS needs to be boot SCSI or Boot other not boot IDE. I've seen this time and again especially with SATA [though motherboard mfgs are getting better with their BIOS requirements to show SATA in boot order].
Poster does not say he changed boot order to reflect SCSI as a bootable drive.
by cg it
by featherman
If it's an Adaptec 7800 series adapter, try going into the SCSI BIOS ( at boot, after the system board POST), and make sure Interrupt 13 Support is enabled, the the SCSI BIOS is enabled and that the Hard Drive SCSI ID number (usually ID 0 or 1) is set as the boot device.
Look in the Adaptec KB here (watch the word wrap for this long URL):
for additional assistance. The 7800 series silicon was/is used on the 2902/04/06; 2920/30/40 series of SCSI cards, so amswers for these cards will probably apply...
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending