Discussion Locked

WAN Upgrade

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how can i submit a proposal to upgrade a 56k dedicated WAN Network with 4 US sites and 1 European site, also upgrade the architecture and protocols for a company that has a 30-40 percent growth rate with 2800 clients and 1800 employees currently using old redundant switches delivering 10 mbps links to 150 severs (novell,unix, & winNT) , lastly need to incorporate voice,data & videoconferencing, this company will add 17 additional sites in 12 months?

6 replies

by silentdeath

Oh Yeah, we have a million dollars to upgrade
the Hdqtrs facility but cost is not driving this train, its how to implement and make it work through a migration period.

by stillatit

I would suggest separate upgrades for the various pieces, so that each piece can be independant of the others, and many can be done concurrantly. Properly done, this will have little negative impact on users.

1. Upgrade internal network to switched 100.
a) Start with upgrading hubs to 10/100 switching or to a large Cabletron (or similar) at 10/100 switched.
b) Verify cable types; repull any cable that is not at least Cat-5.
c) Replace network cards with 10/100 in all machines after wires are checked. Make sure the cards you use have the appropriate drivers available.

(continued in comment)

by stillatit

(continued)

2. Communications
a) Evaluate cost of Frame Relay versus your dedicated lines.
b) Evaluate the possibility of VPN connections available from some ISP's who will carry your network traffic over their backbones using level 2 protocols.
c) Evaluate the feasability of using VPN over the internet. This is the lowest cost solution, and works in many cases. It depends on your volume of traffic and the tolarance for delays. If you decide to use DSL, pick a vendor with solid financials. Many are going down the tubes now.
d) In your evaluations, get quotes for adding the additional sites. Consider the effects of long-term contracts.
e) Be prepared to be flexible. Your European link may be more economical if it is not the same as the U.S. links.
f) Allow a minimum of two months between contract signing and your first tests. Three is more likely.
f) Your new solution should be installed and tested in parallel with your existing network. Once you are convinced it works, cutover one site at a time. Connect the site in parallel with the old network. Change the routing tables and test over a night or weekend (non-critical period if any exist), changing back if needed.

(continued in next comment)

by stillatit

3. Voice
a) If you are that big, you should be getting very good rates from your voice vendor. Evaluate the cost of dial-up traffic between each pair of sites versus the cost of increased bandwidth to allow the voice over IP circuits. Voice over IPmay be more expensive than straight phone calls unless you have a lot of voice traffic between sites. Look at the number of simultaneous calls being made as well.
b) Evaluate each site individually for the feasibility of using a voice T1. In so doing, demand to know the exact cost of such things as Universal Connectivity fees. You can get a good price on a T1 and then have the UCF come in at twice the cost of the T1.
c) Get quotes from multiple vendors and be willing to change vendors. We hada major vendor come down thousands of dollars per month rather than lose our account to another major vendor.

4. Videoconferencing
a) To do quality videoconferencing today you will need at least 384K between sites (CIR, not just port speed). Theequipment should cost between $1,000 to $2,500 per site at a minimum. You can do a low-quality videoconference at lower bandwidth.
b) On a related subject, audio conferencing, you can buy your own conference bridge equipment rather than always using conference services for outside conferences. We bought a 6-port bridge which paid for itself in under three months.

Good luck.

This discussion is closed to new replies.