Discussion Locked

What is OSPF router?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
One of the four Novell 4.10 servers in my radio router LAN is displaying a time-intervaled message saying that a certain IP address is "using my OSPF router'. What does this mean? Secondly, can anyone tell me how to fix a synthetic time problem? I tried using DS Repair. It ran successfully but not did fix the problem. Any suggestions for fixing synthetic time would be greatly appreciated. Thanks, the non-Novell guy.

9 replies

by bchesmer

For the 1st problem go to "Support.novell.com" & query the knoweldge base for TID 2908890.

For the 2nd problem go to "Support.novell.com" & query the knoweldge base for TID 2921231.

Those 2 TID's either should answer your questions or point u in te right direction.

by ab3_tek

OSPF is Open Shortest Path First, a routing algorithm that finds the shortest path between the nodes in question. It keeps a topology map in its routing table and keeps records of the costs of each link.
If you have the router configured to use this protocol then all the other routers on the network also need to use this feature.

by mr_cellophane

A
OSPF - Open Shortest Path First
This is a routing algorithum which chooses the path between two points based on the number of hops. This could mean a direct 256k dial up link being used instead of taking two hops along 10Mb links. Other methods can determine the route based on a "points" system eg speed of link etc.

B
1. Make sure time is correct and in sync.
2. Make sure the replica in question is synchronizing.
("All processed = Yes" from DSTRACE on all servers in the ring)2. Load DSREPAIR -A from any server in the replica ring.
3. Choose "Advanced options menu".
4. Choose "Replica and partition operations".
5. Highlight the Partition indicating a synthetic time error and press Enter.
6. Choose "Repair time stampsand declare a new epoch". (NOTE: This option will not show if -a switch not used)
7. Login as Admin or Equivalent.

by papachuck

Be careful with the synthetic time. That is Novell's way to set the time on each server to the correct time. It time get too far off it can corrupt the NDS database. You may want to be sure you have a primary or a reference server. The reference server can get a time source off the Internet if you have a connection on your Lan. They use port 123 and there are several NTP time servers on the internet for you to use. You can set the time services in the monitor window on the server and there should be enough help for you to set the source.

Also look over the BIOS on your mcahines. We had one that was losing time and got 2 hours off. A BIOS update to the current level fixed the problem....Good Luck.....Chuck

This discussion is closed to new replies.