Discussion Locked

What Patch Level

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running Netware 5. How do I detemine what patch level it is on?

6 replies

by papachuck

type version at the Console : prompt.... It will give the version and service pack level... If no pack is listed than none is installed......Good Luck....Chuck

by rmcpeake

I am confused between what the version command reports, (NO PATCH LEVEL) and what nwconfig reports under SPACK (PATCH LEVEL v4.0 INSTALLED.

by kevin

At the server console go into nwconfig, select Product Options, Select View/Configure/Remove Installed Products, Scroll down the list and you should see something like Spack 5.0.x Service pack for Netware. The x posistion represents the service pack level. If there is not entry then no service pack is installed.

by rmcpeake

The version command does not report a patch level. When I run nwconfig, install products, SPACK reports v4.0 installed. I thought this meant I had patch level 4 installed. This is what initiated my question. What does SPACK refer to?

This discussion is closed to new replies.