Discussion Locked

Which network is best for a new comer?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am new to networking, real new, looking for
the easiest network to setup to get a two
company consolidation underway. Which
networking system would be best for me to
setup and learn on the go? I have a five
port minihub at present for four computers
and soon to include three embroidery machines
and a new server.

8 replies

by resmith

I would setup an ethernet LAN using Cat 5 cable. If you have 10/100 MB Lan cards you can get 100 MB with CAT 5. I would recommend purchasing some small switches that would be capable of running both 10 MB and 100 MB at full duplex. It will allow for the greatest amount of growth.

by larka

Have cable and lan cards 10/100
Hooked up to a hub. Now I need to us a internet protocol to connect the computers for now and the machines later. TCP/IP, Netbios, ect.

by mckaytech

Your hardware sounds fine, although you will obviously have to get a larger hub (recommended) or add another hub when you add the new server and additional machines.

For the network operating system, as much as it pains me to say this, WindowsNT has the gentlest learning curve, the most familiar interface and the most widespread support. Within this forum, there is a huge supply of knowledge and experience on NT with considerably less representation for Linux or Novell.

As you have questions, bring them back here and I think you'll get a lot of support and good advice.

paul

by larka

At present I am sitting with 10/100 lan cards in each computer. I will later setup one of the extras as a base server. I know am trying to learn Protocals; TCP/IP, Netbios, ect. I am looking for any help in this area. As for the base computers Iwill use a mixture of Win98 and Win2000. I have WinNt 4.0 that I am trying to learn also so, one of the computers will be setup on that.
Thank you very much for your help.
Larka

by larka

Thank you. I have purchased Windows NT and I am looking at setting it up on the computers. I still have alot of questions about protocal and various other things. At present I will set my own computer up for double boot so I can look and learn why'll accomplishing work still. I have a Ethernet card and have tried peer to peer setup in order to use hardware from one another instead of purchasing two of everything. I can not make it work so far.

by terminator

Windows NT, set up a server as a PDC and just click on ok to everything on the setup process, read the documentation and the help

But it is really simple

This discussion is closed to new replies.