Question Locked

Why can't DSL Auto-connect work for D-Link router?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I currently have Cincinnati Bell's Zoomtown DSL service in my home. I have two computers but only one is connected to the DSL via a Westell 6100 modem with a single DSL port. I bought a D-Link DSL-2540B modem/router combo with four DSL ports so both computers can connect to the Internet.

The problem is the installation software with the D-Link unit. After all instructions were followed the DSL Auto-connect cycles thru 12 combinations of VPI/VCI settings and fails to complete the set up. The manual set up is too complex and so far I am unable to get the protocol settings from Zoomtown. Can anyone explain what causes this problem?

Thanks,

3 replies

by thumbsup2

I can only think of three possibilities.

(1) Is the phone line plugged into the new modem/router in the CORRECT hole?

(2) Zoomtown won't allow other devices to connect to them. Some ISP's do this ya know.

(3) You have Zoomtown's PPPoE connection software still installed that would be preventing the new one from running.

You might want to check out this link:

http://support.dlink.com/faq/view.asp?prod_id=997

by abbyd9

I can assure you all the plugs are in the correct holes. Zoomtown hasn't mentioned anything about disallowing customer owned equipment. The only reply they send me is:

"We cannot assist in the configuration of Third-Party equipment, such as
your new router. The information I can provide is listed below:

Connection type: DHCP

No IP, Subnet, DNS, etc, should be required. ZoomTown's IP addresses
are provided automatically via DHCP. No username/password is required."

One of the Techs I talked to said something about them not using PPPoE. I do not know how to even look for this. Anything further on item 3 would be appreciated.

Ironsides

This discussion is closed to new replies.