15 replies
by cg it
humm you built it a year ago, it's working great "Except"!!!! you don't know if it'll boot the next time you turn it on.......
might be time to think about not building your next comp and get a Dell ???
by mallmill13
by mallmill13
by mjd420nova
by mallmill13
by thechas
You say that you turn off the surge strip that supplies power to your PC.
While turning the strip off increases protection against surges on the power line, turning the AC power off may be at the root of your problem.
What I suspect is wrong, is that you have a weak CMOS battery. When the CMOS battery gets weak enough, it can cause the BIOS to lock up and not get through the POST process.
When you turn an ATX style PC off, some power is still supplied to the motherboard. Among other things, this power keeps the CMOS settings and real-time clock running.
When you switch AC power off to the PC, the system is forced to run the CMOS and real-time clock off of the back-up battery.
The coin cell batteries used for CMOS backup can last for up to 10 years "if" the PC is usually left with power on. When you turn the AC power to the PC off, the running life of the CMOS battery is significantly shortened.
To test this, try leaving the surge strip switched on and see if the PC now powers up normally after it has been off for a while.
If so, change the CMOS battery.
Chas
by mallmill13
by animatech
When your PC is back up and running have a look at your eventvwr for any errors, Change your CMOS battery, run chkdsk on your system, go through logs on your PC see if you can find some sort of an answer, Change power supply, Open the box and have a look inside see if all cables connected securly, Clean the system and so on...
If it happens 3 weeks ago try to think if there was some sort of power surge, You installed somthing...
by mallmill13
by rskcds
by mallmill13
by robo_dev
I would first unplug it from the surgebar and connect the PC directly to rule out a bad switch or other fault in the surge protector.
Assuming that your power switch is like most AT/ATX power switches, the motherboard is the one deciding to turn on the power supply, or not. The power switch is just a momentary switch connected to the motherboard.
The bottom line is that it is either the mobo,the ps, or the switch. As an extra test, pull/disconnect EVERYTHING except the processor, and try to power on. This would rule out a faulty component that was stopping the motherboard from going thru post.
The PS has multiple outputs 12/5/3.3V. HDD needs 5V and 12V. Getting HDD drive lights only would likely mean that they are getting only 12V...or the motherboard is stuck at the 'drive reset' part of POST.
See the following ATX power supply troubleshooting flowchart:
http://www.fonerbooks.com/power.htm
by mallmill13
by mallmill13
by mallmill13
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending