Discussion Locked

Why can't I see all computers on Network

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 15 computers running on a Novell Netware Network (4.1 I think). All the computers are set up the same as far as gateways, primary network logons and File and Print Sharing, etc. There are 3 computers that I cannot see in my network neighborhood. I am using the Client "Client for Netware Networks", however if I use "Client for Microsoft Networks" I can still see the users in the network neighborhood. There is nothing unusual in the network setup that I can see that would make these 3 computers look any different from the rest. Any ideas? All computers are running W98. TCP/IP protocol...

7 replies

by mail

Are those three computers running the IPX/SPX protocol? Sounds like NetBEUI is installed because you can see everyone when using 'Client for Microsoft Networks.' Try installing IPX/SPX or if it is installed, uninstall it and reinstall. Good luck.

by jim.a.trotter

First of all I would not recommend using Microsoft's client for Netware, use Novell's, do a custom install, and install only what you need. Some of the options are for Zenworks, some are for Netware 5, etc.

Secondly the Novell client has nothing to do with seeing other computers in the Network neighborhood. For that you need the Microsoft client for Microsoft networking. Make sure you have all the workstations assigned to the same workgroup. Enable File & Print sharing and you're off & running.

As far as protocols are concerned, you'll need IPX/SPX for netware and TCP/IP for internet communication. I wouldn't touch NetBEUI if I were you. It's too noisy. Workstations can communicate with each other over IPX/SPX or TCP/IP.

I have a question for you to ponder. You have a network with a file server. If users need to share files, why are these files not located on the server. That's what it's there for. I don't let my users advertise themselves. It creates too much traffic (but I've got a large network). Unless you have a pressing need to have you workstations show up in Network Neighborhood, why bother?

by gsmith

Don't know about W98, but in NT

To hide the PC, at the command prompt type:
net config server /hidden:yes

To let the PC be scene, type:
net config server /hidden:no

This toggles registry setting:
HKLM\CurrentControlSet\Services\LanmanServer\Parameters\hidden

from 0 to 1.

This discussion is closed to new replies.