Question Locked

Why i often need to run "claear xlate" on Cisoc PIX 515E?

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Why i often need to run "claear xlate" on Cisoc PIX 515E?
I am using cisco Pix 515E firewall; I need to use ?clear xlate? command often after 40-45 days then only my internal network connects to internet. Why.
Your valuable commends are welcome.
Thanks.

2 replies

by leeburchfield

Are you running NAT or PAT? Are all of the available IP addresses just getting used up?

This discussion is closed to new replies.