Discussion Locked

Why won't WinXP install after removing Vista RC1

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

You Guys are my last hope, Microsoft was no help.
Have a one year old 64-Bit Computer. Rec'd my Vista RC1 32, DVD in the mail and loaded it on my 64-bit PC. Everything went perfect until I noticed that I couldn't use the Internet. After hours of research found out that the Motherbd maker has discontinued this Motherbd and there are no Vista drivers for the nForce-250 network controller for the on-board Nic card. So, I uninstalled Vista RC1 and tried to reinstall my Windows XP Pro and now I get an error that states "Error loading Operating System" just after "Boot from CD" and of course WinXP setup will not take off after the PC restarts from pre-setup.
Tried all the obvious tricks- Reformatted HD, fdisk from Win95 Boot floppy, even downloaded hard drive utility program to make sure the HD was clean but PC still also says another OS still resides along with Error Loading OS.
Haven't been this upset in years and fear I've lost my 64-bit machine to RC1.
Please, does anyone, know of a solution to get me back to WinXP since Vista dumped on me? I'll be very greatful.

4 replies

by icb's corner

Try to load a system on DVD or CD to check your devices. Could be either Knoppix, other live CD/DVD, or ERD Commander. Remove and put back components on motherboard to be sure there is a good contact between them.

by rob miners

go to bootdisk.com and download the 98 boot disk and create it.

use fdisk to remove the non dos partition. recreate the partition and use the xp cd to boot and install.

by hal 9000

Download Boot & Nuke from here

http://tinyurl.com/4rfur

Then go to the BIOS and short out the Pins to clear it completely or remove the CMOS Battery and leave for at least 30 minutes with the unit unplugged.

Clearly there is something written to the HDD that is making the XP Installer think that there is a newer OS already installed and will not allow the installation to proceed.

You should also check the Date in BIOS as well as if that is wrong and has defaulted back to it's original opening date this could prevent the installation of XP if it is currently showing something like 1999 instead of some time latter than 2001.

Col

by kjohn034

1) use your XP install disc to get to windows recovery (press 'R' when it asks if you want to install windows or repair windows)

2) log in to the install (just press return when asked to log in if you don't have a password)

3) type 'fixmbr'...after warning type 'y' and and then press enter

4) type 'fixboot'...type 'y' and then press enter

5) if all went well power off and try to install XP like normal

This discussion is closed to new replies.