Discussion Locked

WIN2K server not seen in Network Neigh..

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just installed a win2k server has a single server part of a domain. When using TCP/IP nobody could see the server in network neighborhood.And on the server I can't see to other machines. Pinging the PDC or the BDC is ok. Name resolutions is ok.They all have the same domain.

When I install NETBUI on the Server I'm able to see the other machines.Could anybody help me. I tried everything. But with no success.

Marc Derome

17 replies

by jfv62

Remove and re-install the TCP/IP protocol. Your settings are out of wack. Subnet,DNS,WINS,Gateway must all be correct.

by mderome

Thanks Tazz, but I tried this already. Un-installed every protocol and re-installed tcp/ip. Still same problem.

by dmiles

WIN2K will need the Active Directory Services installed to view resources over the network

by mderome

This server is not a PDC or a BDC, but a member server. I already have a domain controller in this case.

by yuli

Windows NT 3.5x,NT 4.0,windows95 and 98 use NetBIOS name resolution. In windows 2000, the primary network protocol is TCP/IP, you do not need WINS and NetBIOS over TCP/IP if there are only windows 2000 servers and clients in your network.In your case, you need to implement a DNS and WINs in your network. if you already have DNS and WINS, your need to specify WINS server ip address in TCP/IP setting of your win2k server, and confgiure your DNS server to use WINS for name resolution lookup. if there is no DNS and WINS server in your lan, the best way is to install dns and wins in your win2k server, because win2k provides integration between dns and wins. if win2k DNS serer can't resolve a fully qualified domain name(FQDN), it converts FQDNto a NetBIOS name and quries a configured wins server.
NETBEUI uses broadcast for name resolution. that is why you can see each other after you install NETBEUI in win2k server.

by tony.colgrove

Sounds like everything is working as expected. Win2K is native TCP/IP and does not lend itself to NETBIOS broadcasting and browsing. On the server you need to Enable NETBIOS over TCP/IP. This can be found in your TCP/IP properties> Advanced > WINS tab. This will provide solution on the local segment. Make sure the server registers with the local WINS server to add it to the browse list.

by daniel lemieux

ok.. windows 2000 server uses Active Directory. I sort of common meeting place for all of the domain settings. Go to network places, then entire network... you should have an icon that is named Active Directory. and thats it... that is your server

This discussion is closed to new replies.