Discussion Locked

Win95/DOS drivers

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running a credit card settlement program. It uses an external modem supplied by Visanet called a posport. We have used this posport on Win95, 98, and DOS. I have never had a problem or have I ever had to set up any special drivers. In onelocation there is a machine that was ordered with NT on it by the local IT guy. To install our credit card server on it he wiped the drive and put a basic win95 set up on it. He call it a a vanilla setup.
The only way we can get the POSPORT to work is to 1. shut down and restart in ms dos mode. Then type exit and have windows restart. It will not work in windows on this machine and it won't work in dos. Only the shut down/exit gets it to work?

Thanks a lot
John Bennie

6 replies

by tchieng

This is a long shot but... go to BIOS setup. Somewhere in there, there should be an option for telling the computer if a Plug'N Play OS is installed or not. If it's on Yes, change it to No. Check that the Serial Ports 1 and 2 are enabled (assuming your ext modem is connected via com ports). Save and reboot.

Also check in the Device Manager to make sure none of the Serial ports are disabled or have a yellow exclamation mark besides them.

What I'm thinking is that your PnP option in the BIOS is set to Yes. When the PC boots up, the BIOS hands over the initialization and configuration of the PC to the OS. So when you boot to DOS, no initialization is done. When you boot to Windows, initialization is done; however, there could be conflicts that exists with the port and some other devices. Like I said, that was a long shot... I could be completely wrong...

by johnbennie

I found out this box which was built for NT in the first place did not have a setting in the bios for PNP OS. This is what seems to be causeing the prolbem.

by mckaytech

I'm thinking along the same lines as the first answer but am wondering if the problem is that the BIOS WAS set up for non-PNP operation under NT and whether legacy ports were defined in a non-standard way.

A BIOS/CMOS problem of some kind is the only thing that makes sense to me but it is kind of a head-scratcher.

paul

by johnbennie

This box was built by Compaq for NT. It did not have a PNP OS option in the bios. So I think this is the problem.

by firelord24

I would agree with checking in your bios to see if you have an option for pnp O/S. For win9x you need to have this set to no. Also I'd check and see if you have a dosstart.bat. This file would load on startup from this method.

This discussion is closed to new replies.