Discussion Locked

WIN95 pc's can't browse after removing N

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Question... I have a flat switched network with 2 domains (staff & student), DNS, primary and secondary WINS servers (pointing to themselves)... In the student classrooms I removed NetBEUI from a few of the pc's as I'm trying to take it off of the network.

The problem I'm now having is that after removing NetBEUI, those pc's can only browse the student side and can't see any of the staff side (which I still want for the techs to upload/download across the network)... any ideas as to why they can't see the entire network? They all have the WINS properties set up correctly.

4 replies

by dft3

It sounds like the WINS servers may not be replicating between themselves.

Make sure you've got each of the WINS servers set as push and pull partners of each other.

by calves

Those two domains must be using the same subnet mask, otherwise on side would never had seen the other without a routable protocol (netbeui is not routable). So, if you had IPX or TCP along with the Netbeui and now doesn't work. Reset you router, ifthat doesn't work, in one client computer, remove all the network settings, reboot it and install it again without netbeui.
That should do it.

Good luck!

by 90proof

I have a flat network, so the router that we use is only used to connect to the internet... we don't use it to route internally since we have a flat network. All the pc's point to themselves for the Default Gateway. Any other suggestions?

This discussion is closed to new replies.